Step 1 Arm Assembly
Be sure the mount is securely fastened to the surface before beginning.
Insert the pole of the arm assembly
into the mount. (Mounts will vary).
Use the 3/32” allen wrench, to tighten
the set screw on the mount. (Tighten
enough so the pole does not spin or
slip through the mount).
Align the tilter and VESA bracket with the hole
pattern on the back of the
fl
at panel monitor.
Use the four (4) M4-12 Philips Pan Head screws to
attach the plate to the back of the LCD monitor.
After securing the plate to the
fl
at panel
insert the tilter into the arm.
Use the 10-32” Philips Pan Head screw
and washer and fasten them to the hole in
the underside of the tilter shaft, locking the
monitor in place.
Tilt the monitor so it faces upward and
locate the set screw under the tilter. Insert
the 7/32” Allen wrench into set screw to
adjust the tilt friction.
* To tighten friction turn the wrench to the
right.
* To loosen, turn the wrench to the left.
Step 1A Arm Height Adjustment
To adjust the position of the extension(s),
loosen the set screw on the back of
the of the extension(s) then loosen the
thumbscrew attached to the collar under
the arm.
The extension(s) and collar(s) will easily
slide up and down the pole. Tighten
the thumbscrew on the collar and the set
screw on the back of the extension(s) to lock into place at the
desired height.
Step 2 Attach Tilter/VESA bracket to the monitor
Step 3
Apple Bracket Assembly Continued
Step 4 Monitor to Arm Assembly
Step 5 Tilt Mechanism Adjustments
Set
Screw
Carefully remove the base from the
fl
at
panel monitor. (See your monitor’s User’s
Guide for instructions on how to do this.)
Attach the adapter plate (75MM or 100MM)
to the tilter mechanism, using four (4) #10-32
x 3/8” Flat Head Philips screws.
