8
A
S
S
E
M
B
L
I
N
G
T
H
E
S
M
A
R
T
S
C
O
O
T
TM
S
E
T
T
I
N
G
U
P
T
H
E
S
T
E
E
R
I
N
G
C
O
L
U
M
N
1.
Lift
the
steering
column
to
its
upright
position
until it locks in place.
2.
P
ull the latch upwards
threading
the
bolt
through
the
center of the locking system.
3.
Turning the lever to the right or left, press down
on the lever to secure the steering column.
4. The steering locking system may loosen with use. Check
frequently and make sure it is tight.
C
O
N
N
E
C
T
I
N
G
T
H
E
S
E
AT
1.
Take
the
seat back
and
slide
it
into
the
slot
underneath
the
seat.
Tighten
the
black
knob
to
secure
the
seat back
to
the
seat. Lift
the seat
back to its upright position. See Figure 1.
2.
Find the seat post and remove the top locking
pin from the post .To remove the pin, continually
press
down
the
small
knob
on
the
end
of
the
pin until the pin is removed completely from the
system. See Figure 2.
3.
Insert the seat into the attached
seat
post.
T
urn the lever on the left while holding the screw
on the right. This tightens the
locking system.
Grab hold of the lever and
pull
it
forward
until
it
tightens.
PLEASE NOTE – Over tightening the
screw will make it difficult for you to tighten the
handle. You might
have
to
loosen
the
screw to
adjust the tension.
The system requires that
you use some force to tighten the latch.
4.
Replace the locking pin into the top hole. Again,
press down the small knob on the pin until the
pin is through both holes in the post.
Instructions for the
seat level and seat back can
be found in this Manual in the
Adjusting
Your
SmartScoot
TM
section.
Lever
Latch
Figure 1
Figure 2
