16
Innovative Circuit Technology Ltd.
Activate Form-C Contact
: Checking this box will cause the Alarm relay to
trigger for an under-current condition.
Send E-mail
: Checking this box will cause the unit to send an output Under-
Current alarm e-mail to the assigned address entered on the
E-mail Setup
page.
Network Setup
Use this page to configure the network settings for the panel. Click on the Save
Settings button at the bottom of the page to save any changes and re-boot the
panel.
Network:
MAC Address:
Displays the MAC address assigned to the panel. It is also
shown on line four of the LCD Network Status screen.
Enable DHCP
: Turn on this setting if your network uses a DHCP server to
automatically assign IP addresses. (Enabled as default setting). To manually
assign a static IP address to the unit uncheck this box, then set the following
parameters.
IP Address
: Specify a unique IP address for the unit.
Subnet Mask:
Specify the mask for the subnet the panel is located on
Gateway:
Specify the IP address of the default router (Gateway) used for
connecting attached devices to different networks.
Primary DNS
: Specify the IP address of the Primary DNS Server for your
network.
Secondary DNS
: Specify the IP address of the Secondary DNS Server for your
network.
Web Server:
CAUTION
:
Changing the web server port numbers may cause loss of communication with
the panel
The following ports may be changed within a range of 1 to 65565, if
required.
HTTP Port
: This port is used for HTTP traffic between the panel and your
browser. The default HTTP port is
80
, and if you change this the new HTTP
