REV. 02/26/2020 PN:
PG:2
2257 route 139
Drummondville, Québec
J2A 2G2
WWW.INNOVAPLAS.COM
BILTMOR DECK 5050
B
C
1 year on pool step.
1 year on hardware.
MANUFACTURER WARRANTY
1)
Snap the four post ends into the
step, making sure that the cylindrical
part is vertical and that the ends are
snapped properly in their respective
housings.
2)
Snap the two feet to the bottom of
the step.
D
E
F
1)
Insert the four posts into the post ends and secure
them in place with the screws provided (see medallion).
2)
Insert the two deck supports over the
rear posts.
3)
Insert the handrails on the two posts
and secure in place.
4)
Fasten the access panel with the
screws provided.
’
3
1/4
’
1/4’’
align screws from
center of plate
1)
Slide the two tie
wraps in place and
place the sand bag
into the riser. Fasten
the tie wraps. Do not
over tighten.
1)
Slowly submerge the
step into the pool. Make
sure you do not damage
the pool liner in the process.
2)
Angle the whole step so that it is entirely under
water. Purge all the air from under the step.
1)
Fill the bag provided
with sand. The approximate
weight should be 5 lbs.
*SAND
*Sand not included
x20
G
x2
E
D
D
4x
4x
x3
D
1)
Insert the two step cups in the riser.*
2)
Place the riser on the ground, install the step
on top of the riser and fasten with the four
screws and plastic screw caps provided.
3)
Snap the screw caps covers in place.
* View step cups installation tips on YouTube:
https://www.youtube.com/watch?v=W5RH1VNxpu0
