Live Data Mode
RECORDING (CAPTURING) LIVE DATA
41
If the erase was not successful, an
advisory message displays.
- To retry the erase process, verify
that the Scan Tool is properly
connected to the vehicle’s DLC
and that the ignition is on. Select
Erase
, then press
ENTER
.
- To exit the record function, select
Back
, then press
ENTER
to
return to the Record Live Data
menu.
6.
Put the engine in the operating
condition that causes the DTC to set.
If necessary, drive the vehicle until
you reach the vehicle speed at
which the problem occurs.
7.
When the Scan Tool detects a fault that
causes a DTC to set, it automatically
records and saves approximately 100
frames of Live Data information in its
memory for each PID selected.
A progress message shows on the
display.
- You can stop and save recorded Live Data at any time by
pressing
ENTER
.
When recording is complete, a confirmation screen displays.
Select
Yes
and press
ENTER
to playback Live Data (see
LIVE DATA PLAYBACK on page 43 for details) or select
No
and
press
ENTER
to return to the Live Data menu, as desired.
If recording was not successful, an advisory message displays.
Press
ENTER
to return to the Record Live Data menu.
Record by Manual Trigger
This option lets you select the precise time at which the Live Data recording
will occur. Record by Manual Trigger can be a very valuable tool when
troubleshooting intermittent problems that do not meet the requirements for
a DTC to set. The Scan Tool can record approximately 100 frames of Live
Data.
1.
With the Scan Tool in Live Data mode (see VIEWING LIVE DATA
on page 37), press and hold
LD
until the Live Data Menu displays,
then release.
2.
Select
Record Live Data
, then press
ENTER
.
The Record Live Data Menu displays.