Innotek Spray Commander, Инструкция по эксплуатации

Страница: 37 / 40

- 37 - - 37 - www.innotek.net
4. Press buttons 2 and 3; the receiver collar should release a small spray (button 2), and a large one
(button 3). If nothing happens when pressing buttons 1, 2 or 3, there may be a problem with either
the transmitter or the receiver circuits.
5. If any of the 3 buttons produces a reaction in the receiver collar, then the transmitter is working.
6. However, if no spray is released with buttons 2 and 3, but button 1 activates the sound signal, then
the batteries could be low, or the device may not be fi lled properly. If all is fi ne in both cases, then
there could be a problem with the spraying mechanism on the receiver collar.
7. If both spray buttons work, but no sound signal can be heard when pressing button 1, then the
piezo buzzer may be faulty.
8. If the device doesn’t seem to hold its contents, or gas can be heard leaking from the collar, please
contact our Customer Care Centre.
If you experience any of the above mentioned problems, please contact our Customer Care Centre.
To purchase additional accessories for your Innotek ® Spray Commander ® Remote Spray Trainer, visit
our website at www.innotek.net to locate a retailer near you and for a listing of Customer Care Centre
telephone numbers in your area.
This product is covered by a 3 year limited warranty. Please see www.innotek.net for warranty details
This equipment has been tested and found to comply with relevant EU Electromagnetic
Compatibility, Low Voltage and R&TTE Directives. Before using this equipment outside the
EU countries, check with the relevant local R&TTE authority. Unauthorized changes or modifi
cations to the equipment that are not approved by Radio Systems Corporation are in violation of EU
R&TTE regulations, could void the user’s authority to operate the equipment, and void the warranty.
This product is in compliance with the provisions of the EMC and LV directives.
The Declaration of Conformity can be found at: http://www.innotek.net/world.shtml.
Separate collection of spent batteries is required in many regions; check the regulations in your
area before discarding spent batteries. Please see page 35 for instructions on how to remove the
battery from the product for separate disposal.
This device operates on 1 battery of the type alkaline with 6 Volt capacity, replace only with
equivalent battery.
Please respect the Waste Electrical and Electronic Equipment regulations in your country. This
equipment must be recycled. If you no longer require this equipment, do not place it in the
normal municipal waste system. Please return it to where it was purchased in order that it can be
placed in our recycling system. If this is not possible, please contact the Customer Care Centre
for further information. For a listing of Customer Care Centre telephone numbers, visit our website at
www.innotek.net.
ACCESSORIES ACCESSORIES
WARRANTY WARRANTY
Compliance Compliance
Battery Disposal Battery Disposal
Important Recycling Advice Important Recycling Advice