Page 5 of 9
Edition 06/12/2014
INNOTECH
FAS 01-03
INNO
TECH
FAS 01-03
APPLICATION
Transport:
Caution
, the fall prevention system for windows utilises spring pre-tension.
Slacken
the fall prevention system for windows before you transport it (Fig. 2). To slacken the
fall prevention system for windows, place it on a solid surface and hold on to the galvanised
(silver) part before releasing the lock by pulling locking bolt
A
.
Caution
, the fall prevention
system slackens (risk of injury). When pulling locking bolt
A
, make sure not to prevent the
galvanised (silver) part from shooting out, as this will damage the restraint system. It is,
therefore, important to extend the system slowly.
Fig. 2
Pre-adjustment:
Hold the slacked fall prevention system for windows with both hands, pull
locking bolt
B
, and adjust the system to the respective window size using the adapter. Correct
setting: = (light width of the window frame plus approx. 50 mm to 150 mm (Fig. 3).
Attention: make sure locking bolt B has snapped back into place after each pre-
adjustment!
Proceed by shortening the fall prevention system for windows by pulling locking A,
pushing the perforated silver extension inward, and releasing locking bolt A again.
Your
fall prevention system is now pre-adjusted.
Fig. 3
Installation:
Keeping at an angle
below 5 degrees
, guide the anchor peg
1
of the pre-set
fall prevention system for windows into anchor point
X
(
∅
10 mm) on the window frame (Fig. 4).
Proceed by pulling locking bolt
A
and carefully insert anchor peg
2
into the opposite bore
Y
that is
marked on the window frame. Release locking bolt
A
to lock the fall prevention system for
windows in place on the window frame (Fig. 5).
Disassembly
in reverse order.
Fig. 4
