IMPORTANT BATTERY CARE:
A ba�ery should never be totally discharged for
a period of �me however, if the ba�ery is totally
discharged it must be recharged to at least 1 bar
before vaping with ‘Vape while charging’
pass-through technology. Ensure the OLED
ba�ery power level has at least 1 bar remaining
before using the ‘vape while charging’ func�on.
READY TO VAPE!
Check that the CoolFire
ULTRA ba�ery is
charged and func�oning properly.
A�ach an atomizer. Ensure that the atomizer
is filled with eliquid and a�ached correctly.
There must be eliquid in the tank before you
power on & ac�vate the device. Do not dry
burn the coil. Always Prime new Coils before
vaping. Always check & confirm the material
and range of the a�ached coil.
Power on the CoolFire ULTRA by pressing the
“ ” Power bu�on 3x.
The screen will display the last selected se�ngs.
Click the “ ” Power bu�on once to bring up
the Coil Selec�on screen:
COIL MODE SELECTION SCREEN
<SAME> - Same coil with previous se�ngs
<Ni> - Ni200 - Nickel Coil
<Ti> - Titanium
<SS> - Stainless Steel 316L
<W> - Wa�age
The ideal temperature or wa�age varies
according to coil, eliquid, tank airflow and
personal preference. Start at the low end of the
recommended coil temperature or wa�age
range and increase the set temperature or
wa�age un�l you find your perfect vape
temperature and flavor.
You must select the correct coil mode before
vaping.
CALIBRATION AND COIL SELECTION
IMPORTANT:
For accurate calibra�on the coil must be at
room temperature. If a coil has been heated
then it must be cooled down to room tempera-
ture before calibra�on. Eliquids should be
room temperature for accurate calibra�on, if
an eliquid is cold then it must be warmed to
room temperature before calibra�on.
IMPORTANT:
You must select the correct coil type. Set the
CoolFire ULTRA Temperature or wa�age according
to the a�ached coil’s recommended range.
Do not set the temperature higher than
recommended or you may damage the coil. If
the coil is damaged, or tastes burnt, replace
the coil immediately.
8
9
