Innohome SGC430-1U3-50, Справочное и монтажное руководство

Страница: 19 / 24

Checking the
sensitivity level
1. Remove the Sensor from the
installation plate. (The Sensor
gives 4 “beeps” ( ) and the
cooker is switched off.)
2. Press and hold the button
(approx. 10 sec.) until 2 “beeps”
( ) are heard.
3. An unadjusted Sensor’s sensi-
tivity setting is level 8, and when
checking the level, the Sensor
gives a set of “beeps” as follows:
8 - 8 - 5 - 8. If the sensitivity was
adjusted to level 4, the sensor
would give “beeps”: 4 - 4 - 5 - 4.
Reset the Heat Sensor
to factory settings
Remove the Sensor from the
installation plate. (The Sensor gives
4 “beeps” ( ) power is cut off
to the cooker).
1. Remove the battery lid.
2. Press the button once.
3. Return the battery lid. The Heat
Sensor shall make a "beep".
4. Press and hold the button until
the three "beeps" are heard.
Release.
If three "beeps" cannot be heard,
something went wrong. Repeat
from Step 1. Return the Heat Sensor
to its installation plate and press the
button once.
“BEEP” “BEEP” “BEEP”
1
2
3
4
“BEEP” “BEEP”
19
Note!
The Heat Sensor must be
placed on the mounting plate
during pairing.
1. Switch off the power for 15
seconds and switch it back on.
2. Within one minute from the
power reset, sweep the side of
Control Unit with the bottom
magnet of the mounting plate
so that the Control Unit makes
a buzzing sound. The Control
Unit is now ready to be paired.
3. Press and hold the button of
the NEW Heat Sensor until
it emits a “beep” and a red
LED flashes. The Control Unit
makes now a buzzing sound.
4. After 5 seconds, the Heat
Sensor gives an alarm (first
one "beep" and after a while
continuous beeping).
The Control Unit and the Heat
Sensor are now successfully
paired.
5. Reset the test alarm by press-
ing shortly the Heat Sensor
button. Check that the cooker
can be turned on. If the Heat
Sensor does not respond or
if the test alarm cannot be
reset, first repeatthe pairing
procedure and then see FAQ,
page 22, points 5 and 6.
Pairing devices
The units are already paired at the factory.
When replacing the Heat Sensor or the
Control Unit, the devices must be paired again.
Watch the film:
https://vimeo.com/321504101
Checking sensitivity
Watch the film:
https://vimeo.com/321504446
Factory settings