Innodisk SATADOM-SH 3SE Series, Руководство пользователя

Страница: 7 / 20

SATADOM-SH 3SE
7 Rev 1.3 TPS, Jan., 2015
1. Product Overview
1.1 Introduction of Innodisk SATADOM-SH 3SE
Innodisk Serial ATA Disk on Module (SATADOM) supports SATA III standard (6.0Gb/s) interface
with excellent performance, and SATADOM-SH 3SE is designed as the smallest form factor size
that could enhance compatibility with various design applications. Particularly the 7th pin of
standard SATA 7pin connector can optionally be the built-in power VCC pin. In other words, it
could be connected directly to the SATA on-board socket on customers’ system without additional
power cable. Besides, the booting time for operation and the power consumption is less than
hard disk drive (HDD). SATADOM-SH 3SE can work under harsh environment compile with ATA
protocol, no additional drives are required, and the SSD can be configured as a boot device or data
storage device.
1.2 Product View and Models
Innodisk SATADOM-SH 3SE is available in follow capacities within SLC flash ICs.
SATADOM-SH 3SE 1GB
SATADOM-SH 3SE 2GB
SATADOM-SH 3SE 4GB
SATADOM-SH 3SE 8GB
SATADOM-SH 3SE 16GB
SATADOM-SH 3SE 32GB
Figure 1: Innodisk SATADOM-SH 3SE
1.3 SATA Interface
Innodisk SATADOM-SH 3SE supports SATA III interface, and compliant with SATA I and SATA II.
SATA III interface can work with Serial Attached SCSI (SAS) host system, which is used in server
computer. Innodisk SATADOM-SH 3SE is compliant with Serial ATA Gen 1, Gen 2 and Gen 3
specification (Gen 3 supports 1.5Gbps /3.0Gbps/6.0Gbps data rate). SATA connector uses a
standard 7-pin signal segment.