Device Overview
HomePlug AV 200P-I1
The Description of each labeled part is described in the table below:
1.0 DET LED
Blink when detect the presence of other HomePlug 1.0 devices that
have the transmission rate of 14 or 85 Mbps.
Note: Due to the incompatibility of HomePlug AV 200 with
HomePlug 1.0 devices, the presence of the HomePlug 1.0 devices
within the powerline network will thus reduce the performance of
your powerline network.
Power LED
Lit when the power is on.
PLC
(Powerline Link/Act)
LED
Lit when a network has been established.
Blink after Sync button is pushed (see Sync button description below)
Blink quickly when powerline data is transmitted or received.
ETH
(Ethernet Link/Act)
LED
Lit when an Ethernet data signal is transmitted or received.
Sync Button
Used to establish a LAN network with other powerline devices.
Press this button for
1~3 second(s)
and release it to set device into
powerline Sync state.
Reset Button
Press this button for
1~3 second(s)
to restore the device configuration
to factory default.
Ethernet Port
Connect the HomePlug AV device with an Ethernet device (e.g. PC or
modem router) with the Ethernet cable included.
Power Plug
Plug into an electric socket to draw power and to form a powerline
network with other HomePlug AV devices.
Ethernet Port
1.0 DET LED
POWER LED
PLC LED
ETH LED
SYNC button
RESET button
Power Plug
9
