3. Select “INNO FLASK” shown on the list of the Bluetooth device.
If “INNO FLASK” does not appear on the device’s display, repeat from 2.
==PAGE 6==
• Un-pairing Bluetooth
power Off The product or deactivate Bluetooth wireless mode On your device.
• AUX source play back
- Connect your auxiliary source to the AUX-In jack on the right side of the Product with 3.5mm AUX cable.
• LEDs
White LED (Bluetooth indicator)
Power ON: Slow blinking (0.5Hz)
Wait pairing mode: Fast blinking (2Hz) Bluetooth paired: Always ON
Red LED
Battery in-charging: Always ON Battery low: LED flash 6times/1min Battery full charged: LED off
Bluetooth Device reset: LED flash 5times
• Tone sound
When power On: ‘Bebebebeep’ tone up.
When power Off: ‘Bebebebeep’ tone down.
When a Bluetooth device paired: ‘Bebebeep’ tone up
• Set a speaker unit with the case as show in the figure.
INNO Flask Case
==PAGE 7==
Safety Instructions
As with general electronic product, precautions should be observed during handling and use.
• Read this instruction carefully and keep it. Heed all warnings and follow the instruction.
• Do not use the Product near water.
• Clean only with dry cloth.
• Do not block front or rear grilles.
• Do not install near any heat sources such as stoves.
• Protect the power (USB) cable from pressing by heavy substances or pulled by excessive power.
• Only use on horizontal and flat place.
• Unplug the Product during lightning storms or when unused for long periods of time.
• Contact a designated AS center when the power (USB) cable damaged, spilling liquid on Product, exposing Product to
rain for long time, serious damage on Product by dropping it.
• Keep away magnetic recording devices from the Product as there may be a small amount of magnetic flux leakage.
• Only use under 50
℃
of environment to prevent any damage to built-in battery.
==PAGE 8==
• Do not dispose of in the household waste, as the product contains a built-in battery and should be treated and
disposed
according to regulations on waste disposal.
• Sudden movement from clod to hot environment may cause moisture condensing on the Product and degrade system
performance and decrease product life span.
• Protect product from direct sun light.
• Do not use solvents to clean the Product and keep away from dusty environment.
• Do not attempt to disassemble the Product.
