Remove any burrs with sandpaper.
6. Producing a Flat-/Etagen-Distribution box with 12 or
18 INNO-Flex-Duct connections:
a) Open the main body V1 at the cutting edge
X
and
Y
,
as discribed under 6.
b) Open the body at the cutting edge of V2
[
.
The two main body V1 and V2 can now slide into each other.
method of producing a Flat-/Etagen-Distribution box with 18
ports, analog to the aforementioned steps.
A production of distributors with more than 18 ports is not
recommended, since the required air flow can not be guaran-
teed.
Note:
The plug-in edge is provided before the final connecti-
on to a peripheral Silikonwulst to ensure air tightness in
accordance with german DIN EN 1610.
7. Manufacture of central distribution box
with 12 or 18 INNO-Flex-Duct connections:
Flip the lid
\
with a medium-strong hammer hit each on the
bottom and the top of the connected body, as described
under 4.
Shorten a connecting pipe-to-edge
^
to create a connector for central distribution.
Plug the connecting pieces in a main body and the second
Body to this connection.
Note:
The plug-in edge is provided before the final connecti-
on to a peripheral Silikonwulst to ensure air tightness in
accordance with german DIN EN 1610.
method for producing a central manifold with 18 ports, ana-
log to the aforementioned steps.
A production of distributors with more than 18 ports is not
recommended, since the required air flow can not be guaran-
teed.
For the production of through distributors refer to the page
where you want to take the pipe on the lid
\
and install an
additional connecting pieces.
Instruction Manual
© INNO-Products GmbH - Print-No. 1031.2.GB 01.2009 as of INNO-Flex-distribution is subject to change. Illustrations and specifications are subject 3
Body V1
Body V2
Connector
\
]
INNO-FLEX-Distribution-Box
