CMOS setup
75
!"
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple sector
read/write. If your IDE hard drive supports block mode (most new drives do), select
Enabled for automatic detection of the optimal number of block read/writes per sector
the drive can support.
The Choice: Enabled, Disable.
!"
On-Chip USB Controller
Select Enabled if your system contains a Universal Serial Bus (USB) controller.
The choice: Enabled, Disabled.
!"
USB Keyboard Support
Select Enabled if your system contains a Universal Serial Bus (USB) controller and you
have a USB keyboard.
The choice: Enabled, Disabled.
!"
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has no
floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
!"
Onboard Serial Port 1
This item allows you to determine access onboard serial port controller with which I/O
address.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
!"
Onboard Serial Port 2
This item allows you to determine access onboard serial port controller with which I/O
address.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
CMOS setup
76
!"
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller
with which I/O address.
The choice: 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7, Disabled.
!"
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal unless your hardware and software require one of the other
modes offered in this field.
The choice: PS/2, EPP1.9, ECP, ECPEPP1.9, SPP, EPP1.7.
