5
©1996, 1997 - INLINE, INC. IN3213 / IN3262 OPERATION MANUAL - REV 1.1 09/05/00
Optional Accessories
Input / Output Extension
Cables & Adapters
Mounting Brackets
IN8412 High Res. 13W3 Extension Cable, 12’
IN8425 High Res. 13W3 Extension Cable, 25’
IN9072 13W3 Male to (4) BNC Male, 6’
IN9073 13W3 Female to (4) BNC Male, 6’
IN9127 Mounting Brackets - “L” brackets attach to
sides of unit for mounting to a flat surface
IN8000 Series High Res. VGA Extension Cables w/
15 Pin HD Connectors, Lengths from 3' to 100'
IN9045 15-Pin HD Male to (5) BNC Male, 12’
IN9046 15-Pin HD Female to (5) BNC Male, 12’
IN9127 Mounting Brackets - “L” brackets attach to
sides of unit for mounting to a flat surface
TROUBLESHOOTING
The display device connected to the IN3213 / IN3262 output has a bad/scrambled image.
Solution 1: The display device connected to the output of the distribution amplifier may not be compatible
with the computer output. Many LCD panels and data monitors will not display signals at
resolutions higher than 640 x 480 or 800 x 600 or horizontal scan rates above 36 KHz or
48KHz. Make sure you know what resolution mode the computer video card is set to output.
While basic 640 x 480 VGA at 60 Hz refresh rate runs at 31.5 KHz, SVGA modes can be as
high as 48 - 58 KHz with the highest resolution settings such as 1600 x 1200 running at 80
KHz or higher depending on the refresh rate setting. Sun and SGI computers usually operate at
61KHz, 64KHz, or 71KHz at resolutions as high as 1280 x 1024.
Solution 2: The output cable may have a bad sync line. Try another cable.
The output image is missing a color.
Solution: The output cable may be bad. Check both ends of the cable to see if any of the pins are bent or
missing. Also inspect the cable to see if the coax may have been pinched or severed internally.
Try another cable.
When using the IN3262, the computer output is black and white when it should be color.
Solution: There needs to be a termination on the loop-through output. Use a local monitor or the IN9031
termination plug.
The output image of the IN3213 / IN3262 is visible but has poor quality / low definition.
Solution: The output cable may be too long or of poor quality. INLINE offers several high resolution
mini-coax cables for analog signals and a series of shielded twisted pair cables designed
specifically for digital video signal transmission. See page 2 for specific recommendations.
The unit doesn’t output any signal and the power light is not turning on.
Solution: The power adapter may have failed. The power adapter should feel warm to the touch after it
has been plugged in for a few minutes. If the adapter feels cool it may have failed. Try
another IN9204 9VDC; 500 mA power adapter.
