Inland DB-100, Инструкция по эксплуатации

Страница: 11 / 16

11
ASSEMBLY
Optional leather wiper
The included leather wiper helps reduce
the amount of over spray that might be
carried from the blade to the upper wheel
chamber. Follow the instructions below to
properly install the leather wiper.
1
Open the front cover. There is a slot
located on the upper left side of the
lower wheel chamber. This is where the
leather wiper is installed.
2
Using a pair of pliers, compress one
end of the leather. Clamp down hard.
3
Apply a small amount of dry soap or
wax to the crimped end.
4
Using your pliers, push the crimped
end into the slot so that the edge
of the leather just brushes against the
blade. (Fig. I). *IMPORTANT NOTE: Make
sure the leather wiper does not push
the blade out of its normal path. Fig. J
shows correct installation.
Installing the drain tube
The drain tube must be installed when
using a diamond band saw blade. This
drains the dirty, used water so you don’t
use recycled water.
1
Take the included plastic drain tube
and straighten the tube by soaking it
in warm water for a few minutes. Pull it to
remove any kinks.
2
Slide the drain tube onto the large
stem located at the bottom front of
the saw (Fig. H).
3
Place the opposite end of the drain
tube into a bucket or collection
container(not included).
4
Position the saw to the front edge
of your work bench, with the drain
tube lying flat and extending straight out
and down into the collection container.
*NOTE: Periodically remove the drain tube
and flush out any cutting residue with
clean water to prevent clogs.
Fig. H
Fig. I
Fig. J