Rev W4.00D
2. Installation
Please follow these installation instructions closely for each cartridge. Note that you must install the full set of cartridges
provided. Proper cartridge functionality is not guaranteed when mixing the cartridges from this set with any other cartridges,
including your original EPSON cartridges.
2.5 PRIMING: Attach the included priming attachment tip to the syringe (image 3):
2.1
*** VERY IMPORTANT ***
Ensure that the air vent hole on the cartridge is not
blocked. This is
required so that ink can flow correctly.
Please DO NOT cover these air vent holes for any
reason.
Remove any tape or plug if present.
2.3
*** CRITICAL ***
Your ink kit may have been supplied
with sharp needles which can cause
damage to the delicate cartridge wall membranes if you are not attentive.
It is therefore VERY IMPORTANT to insert the needle straight down
(image 2) to avoid damage to the cartridge walls.
2.4 Using the method described above, inject 20mL of ink into the cartridge
through the fill hole. Inject slowly to avoid the formation of air bubbles.
When sucking ink from the bottle into the syringe, put the needle in deep to
avoid sucking any air bubbles into the syringe. Note that the top-left
“damper” compartment will remain unfilled at this point.
Please DO NOT inject any ink into the air vent hole.
2.2
Note where the fill hole is located (image 1) and
remove the plug from the fill hole.
*** IMPORTANT ***
Do not shake the ink bottle prior to use.
Fill Hole/Ink Plug
Air Vent Hole
Damper
Image 1
Image 3
Image 2
