38
5.4 Failure and warning icons
5.4.1 Failure icons and meanings
Icon
Name
Fault cause
Solution
Mixing Tank
Empty
Initial start up. System leak. The solvent
components in the Mixer are vaporized
after long-term storage of the printer
It is suggested to drain
the old ink and fill the
new ink.
Charge
Fault
Nozzle blockage
Clean the nozzle with
nozzle flush and start it
up again after drying
Poor breakpoint
Conduct "breakpoint check",
and adjust it to the optimum
breakpoint position
The Ink jet position is incorrect
Conduct "Ink Jet alignment",
and adjust it to the optimum
position
The ink is out of warranty period or is
polluted
Remove all ink and replace
with the new ink
Filter blocked
Replace the filter. For details,
please consult the service
engineer.
Gutter
Fault
The nozzle is blocked or miss aligned
ink jet. Ink not entering the gutter
Clean the nozzle, clean
printhead, and start it up
again after drying
Long-term storage without correct stop
procedure can cause blockage of the
recovery pipe
Soak and clean the gutter
pipe with solvent until it
becomes unobstructed
High-Voltage
Leak
The printhead has not been cleaned
for a long time, causing excessive ink
accumulating around the high-voltage
deflection component
Clean the high voltage
deflection plate in the
printhead, thoroughly clean
it and start it up again.
No Ink
Chip
No ink cartridge or inserting the wrong
ink cartridge
Insert the certified ink
cartridge
Np Solvent
Chip
No solvent cartridge or inserting the
wrong cartridge
Insert the certified solvent
Cartridge
