Page 9
3. Photocell 2
:
o
Level
: The corresponding function selected is triggered when the photocell 2
obtains the high / low level signal;
o
Function
: Disable, Reset counter, Traversing print control , Reset traversing
print , Opposite print and Reset detection & counting are optional.
4. Print Mode
:
o
Continuous :
Enable continuous print mode
o
Single :
Enable single print mode
o
Reverse :
Enable traverse print mode
o
Times :
Enable repeat print mode
•
Print times
: Only active if the Times mode is selected and prints a set
number of times for a single print trigger
5. Reverse Print Configure:
o
Print Times
: Sets number of prints for each sensor trigger
o
Forward
:
•
Forward delay
: Sets the delay in milli seconds of the first print in the forward
traverse
•
Print Count
: Use to set forward print times
•
Print Interval
: Set the interval between each forward printings.
•
Print Inverse
: Enables on reverse / inverse print on alternate prints on forwards
traverse
o
Opposite
:
•
Opposite delay
: Sets the delay on first print of the return traverse
•
Print Count
: Use to set opposite print times
•
Print Interval
: Set the interval between each opposite printings.
•
Opposite Inverse
: Enables on reverse / inverse print on alternate prints on
return traverse.
6. Shaft Encoder:
o
Internal interval
: Set when no encoder fitted. Sets width of print in time
o
External interval
: Set when external encoder fitted
o
Measure
: Selected when meter marking
o
Pulses per meter
: Calibrates the encoder in use to meter mark. The number of
pulses per meter is set in the pulses per meter box. For example, if the
circumference of the encoder wheel is 250mm and the pulses per revolution of the
endcoder is 2000 then number of pulses per meter is (1000÷250) x 2000
＝
8000
pulses per meter.
o
Print length
: This is the number of pulses to trigger a printing in continuous mode
7. Print Mode:
o
Mode Selection
: Normal, High Quality, High Speed.
o
Level
: Range 0 to 15(For High Quality Only)
8. Manual Print:
o
Manual Print
: Enable the “Manual Print” button on the main screen.
