INKCUPS PAD PRINTERS
ICN-B100
¤
All rights reserved by Inkcups Now Corporation Page 26
V:91719
PROBLEM SYMPTOMS
POSSIBLE CAUSE
LIKELY SOLUTION
Printing head slides down
when it is moving forward
or backward.
Malfunction of proximity
switch located at S2 or S3.
Circuit board or I.C. fails to
work.
Change proximity switch.
Change circuit board or I.C.
Printing head cannot
move downward.
Malfunction of proximity
switch located at S1 or S3.
Solenoid valve is broken.
Change proximity switch.
Change solenoid valve for
up/down movement.
Printing head moves
downward beyond the
control of proximity switch.
Failure of proximity switch
located at S1 or S4.
Change proximity switch.
Conveyor is getting stuck
and cannot move.
The position of chain is
incorrect after conveyor is
adjusted.
Something wrong with the
cylinder inside the conveyor.
There may be stuffs inside
the conveyor.
Adjust the conveyor locking
screws on left/right side of
conveyor.
Change the cylinder.
Remove the stuffs.
No power supplied to the
hot air control unit.
Fuse is short-circuited.
Power switch or the plug of
this unit is broken.
Check if the heating tube
and heating indicator is
short-circuited. If not,
change fuse.
Change the hot air control
unit, power switch or power
plug.
Only cool air is blowing.
No hot air blowing.
Fuse is short-circuited.
Heating tube is burned out.
Ammeter is burned out.
Check if the heating tube
and heating indicator is
short-circuited. If not,
change fuse.
Change the heating tube.
Change the ammeter.
Printing head only moves
forward and stop there
when you turn on the main
power switch.
Foot switch is short-circuited.
START/STOP key on the
front panel is short-circuited.
Change the foot switch.
Change the circuit board.
Содержание ICN-B100
Страница 1: ...ICN B100 PA D P R I N T E R M A N U A L...
Страница 42: ...0 1 0 1 66 0 9 6 7 2 6 7 5 9 12 6 7 7 1 836 12...
