The m6 bolt is removed from the car frame. This brack-
et is attached to the plastic resonator box that will be
removed. This is one of the three m6 bolts that will be
removed.
Page 2 of Part# SP1870
Figure 11
Use a 10mm Socket and rachet and remove the 5- 10mm
bolts on the intake resonator located on top of the valve
cover
Detach the crank case breather line from the intake air
duct
Detach the air duct from the air box assembly
Loosen the clamp on the intake air duct attached to
the throttle body
Loosen the clamp on the air duct attached to the air box
assembly.
Remove the entire resonator box and air duct assembly
out.
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
FIgure A:
Use a torx screw driver to remove the two torx
screw attached to the MAF sensor.
Figure B:
Unplug the
MAF sensor harness.
Figure C:
Remove the MAF senor
from the air box assembly
Figure A:
Remove the two plastic screws on the air
box scoop.
Figure B:
Remove the entire air box
assembly
Figure 10
Use a 10mm socket, extension and rachet and loosen
the two 10mm bolts on the air box assembly.
B
A
C
B
A
Figure 8
Figure 9
You will now need to remove the front bumper. Looking
at the driver side corner, you’ll notice the remaining
two m6 bolts that will be removed from the air box res-
onator brackets. These bolts will need to be removed
Once all three bolts have been removed, continue to
pull the resonator box out.
Figure 12
Figure 13
