Figure 51
Figure 53
Figure 52
The secondary intake is lowered into the resonator
opening and aligned to the primary intake.
The secondary intake is now pressed into the 3” hose
located on the primary intake.
As the secondary intake is pressed into the 3” hose,
the intake bracket is aligned to the vibra-mount stud.
The remaining fender washer and m6 flange nut are
used to secure the secondary intake.
Tighten the m6 flanged nuts to secure the intake
brackets to the vibra mounts.
The 15mm hose is pressed over the crankcase vacu-
um port.
The filter is now aligned to the end of the intake.
The 15mm hose is now installed.
The remaining end of the 15mm hose is pressed
over the intake port.
And reattach the front bumper.
Now reattach the fog light bumper harness to the har-
ness on the car.
Once the intake end is sitting flush to the filter stops,
continue the tighten the filter neck clamp.
Figure 59
Figure 58
Figure 57
Figure 56
Figure 55
Figure 54
Figure 62
Figure 61
Figure 60
