Again with the pliers loosen the spring clamp and
detach the coolant hose from the thermostat housing
as pictured.
Using a spring clamp saved from the last step attach
one end of the included 10mm hose to the thermostat
housing coolant port, replacing the hose from figure
27.
Once the step hose is placed onto the throttle body,
you can tighten the .040 clamp only (throttle body
Side). Leave the 048 clamp loose for now.
The vibra-mount is aligned to the pre-tapped hole as
shown above.
Figure 28 shows the coolant line that was just
removed.
Retain the two spring clamps from the coolant line as
it will be reused in the next step.
With the second spring clamp saved. Attach the
other end of the 10mm hose to the coolant port under
the throttle body, replacing the line hose from figure
25.
Place one .048 clamp (X-4004) and one clamp
(X-4003) clamp over the step hose. Press the 2 3/4”
end over the throttle body.
Use a 10mm socket and 3/8 ratchet to remove the
lower 10mm bolt attaching the support bracket on the
driver side shock tower.
Remove the 10mm bolt, this is where the vibra-mount
will be installed.
The vibra-mount is screwed in until it sits flush with
the strut tower mount.
The secondary vibra-mount is now aligned to the pre-
drilled hole located on the resonator opening as
shown.
Figure 27
Figure 29
Figure 28
Figure 30
Figure 31
Figure 32
Figure 35
Figure 34
Figure 33
Figure 36
Figure 37
Figure 38
(A)
(B)
