Screw the first vibra-mount into the stock air box
brace located by the firewall and the throttle body.
Both vibra-mounts are now installed and ready for the
next step.
Place the one clamp on each end of the 90 degree
elbow. Place the 90 degree elbow over the throttle
body then semi-tighten the clamp on the throttle
body. Press the grommet into the 3/4” hole in the
elbow then press the grommet into the hole (A).
Take air temperature sensor and press it into the
grommet located in the 90 degree elbow(A). The air
temperature sensor is now installed.
For this installation remove the negative and positive
battery terminals, then proceed to remove the battery.
A;ways place the battery on a table or cardboard paper
in order to prevent grounding of the battery.
Now you are ready to remove the
Disconnect any vacuum lines connected to the stock air box and remove the
stock air intake box from its stock location
Remove the stock air intake duct connected from the box to the throttle body.
Once the battery has been removed continue to
remove the plastic try and metal battery tray.
Take the air temperature sensor and press it into the
grommet placed in the 90 degree elbow.
(A)
Screw the second vibra-mount into the brace next to
the thermostat housing
(A)
)
