Slip the filter over the end of the intake until it butts up
against the stop. Tighten the filter neck clamp to pre-
vent the filter from slipping off.
Once you have completed the installation and aligned
the intake for the best possible fit, continue to tighten
all nuts, bolts and clamps. Place the air scoop back to
its original position and tighten the bolts.
Insert the secondary intake in the resonator opening and
align the intake bracket to the vibra-mount stud.
Align intake bracket to the vibra-mount stud (A).
Use the m6 flange nut and fender washer to hold
the intake in placed (B).
Page 3 of part# SP1202
Insert intake end into the inlet side as shown above.
Adjust the intake bracket to the vibra-mounts stud
and semi-tighten clamp.
The entire cold air intake is now installed. Continue
to adjust the entire intake assembly for best possible
fit, prior to moving on to the final instruction.
(A)
(B)
>>>>
>>>>
1. Upon completion of the installation, reconnect the negative battery terminal before you start the engine.
2. Align the entire intake system for the best possible fit. Once the intake has been properly fitted continue
to tighten all nuts, bolts and clamps.
3. Periodically, recheck the alignment of the intake system and make sure there is proper clearance around
and along the length of the intake. Failure to follow proper maintenance procedures may cause
damage to the intake and will void the warranty.
4. Start the engine and listen carefully for any odd noises, rattles and/or air leaks prior to taking it for a test
drive. If any problems arise go back and check the vacuum lines, hoses and clamps that maybe causing
leaks or rattles and correct the problem.
5. Check the filter for excessive dirt build up. Clean or replace the filter with an original Injen filter (can be
bought on-line at “injenonline.com”). Congratulations! You have just completed the installation of the
best intake system sold on the market. Enjoy the added power and performance of your new intake
system.
