Switch on the mains power supply to the pump.
Press the ON/OFF key to start the pump.
Turn the frequency knob fully clockwise so that the display shows 099 (This is the maximum frequency setting of the
pump). Make sure all the air is primed out of the system by opening the bleed valve until liquid flows out in a
continuous stream. Close bleed valve.
Pump is now in operation.
Adjust the knob to the desired percentage frequency to achieve required dosing flow.
Note-
By pressing the button once, the strokes per minute (spm) value is displayed.
Pressing a second time displays the input voltage.
Press once again to show the percentage dosing.
Startup
Typical mounting set up
schematic
