Air2-MC300 | © 2020 Inim Electronics S.r.l.
9
3.1 Enrolling a wireless device
"UUFOUJPO
Be careful not to remove the circuit from its housing.
3. If you are using terminals T1 and T2, pass the cables through the cable entry and connect them. Take
care to ensure that inadmissible cable filaments do not come into contact with each other or with the +
clip of the battery.
4. Hold the base to the chosen mounting placement and mark the points for the base attachment and
tamper protection.
5. Using the screws, secure the base and the tamper protection in position.
6. If you wish to fit the magnet by means of the screws (included), remove the magnet base by means of
a flat-bladed screwdriver.
7. In accordance with the installation requirements, use the base of the magnet with the necessary
height, from the three available.
8. Position the magnet base on the desired side (long or short) of the magnetic contact at a distance of
about 2mm.
/PUF
If you are using the long side, centre the notches on the side of the base in such as way as to obtain the correct
alignment and functioning capacity of the magnet. In the case of the short side, align the magnet with the detector
itself.
9. Using the screws or the adhesive tape, attach the magnet.
10. Remove the battery tab.
11. Re-attach the cover to the base of the contact and replace the enclosure screw.
12. Enroll the device.
3.1 Enrolling a wireless device
The enrolling procedure allows you to associate a wireless device INIM with the transceiver Air2-BS200
which acts in conjunction with the intrusion control panel.
This procedure varies depending on the control panel in use and the programming software or application:
1. Access the control panel programming.
2. Select the device to be enrolled in accordance with its type:
an input terminal, for a detector (motion detector, magnetic contact, etc.)
an output terminal, for an output device connected to a terminal of a magnetic contact Air2-
MC300
a keypad
a sounder/flasher
a key, for a remote control device, selecting as the associated reader the one simulated by the
transceiver
3. Set the device as “Wireless”.
4. Start the learning phase from the control panel.
5. Press the
ENROLL
button on the wireless device.
6. If you are enrolling an output device that is connected to an output terminal of Air2-MC300 it is neces-
sary to enable the “Broadcast RF” zone option.
