Inhep Digital Security IDS 805, Руководство пользователя

Страница: 15 / 28

15
IDS 805 User Manual 700-266-01C Issued March 2009

If the ARMED indicator remains lit, an error was made while entering the user code, press the [#]
key, and re-enter the code.

Once the system disarms, the ARMED indicator will turn off and the keypad buzzer will stop
sounding.

If no valid user code has been entered by the end of the entry delay period, an alarm condition
will be registered.

If the entry period is too short, have your installer change the entry delay period.

If four incorrect user codes are entered consecutively while either arming or disarming the
system, the keypad will be non-responsive for 30 seconds. Your monitoring company will also be
notified on a keypad tamper.
NOTE:
If the ARMED indicator is flashing upon entry, there has been a violation. The intruder may still be inside!
Call for assistance.
NOTE:
If a strobe (or flashing light) has been installed and an alarm condition is registered, the light will continue
flashing after the siren has stopped sounding. Entering a valid [USER CODE] will cancel the strobe.
7.2 To Disarm with a Key-switch or Remote Control
1. Press the remote button or twist and release the key-switch.
2. The system will disarm and the remote indicator (if installed) will turn off.
3. If programmed to do so, the siren will sound briefly - verify with your installer.
8. Emergency Situations
8.1 Fire Alarm
Hold down the [F] key until the beep

If the [F] key is pressed until the keypad beeps (approximately 1 second) a FIRE ALARM
condition will be activated.

The FIRE ALARM CONDITION can also be triggered by a smoke detector connected to an
appropriately programmed zone.

The siren will sound (1 second on, 1 second off) and the FIRE REPORTING CODE will be
transmitted to the monitoring company.

To silence the siren enter a 4 digit [USER CODE]. The siren will stop sounding after 10 minutes
if no user code is entered.
8.2 Panic Alarm
Hold down the [P] key until the beep

If the [P] key is pressed until the keypad beeps (approximately 1 second) a PANIC ALARM
condition will be activated.

Any FIXED PANIC or REMOTE PANIC buttons which may have been installed can also activate a
PANIC ALARM.

If audible panic option has been selected, the siren will sound. A PANIC REPORTING CODE will
be transmitted to the monitoring company.

To silence the siren, enter a valid 4 digit [USER CODE]. If the siren is not cancelled, it will stop