Ingeteam Ingecon Sun Smart TL, Руководство пользователя

Страница: 21 / 64

AAY2000IKE03 21
Ingeteam Energy, S.A. User manual
D
E
EN
ES
FR
IT
PhiCos Cosine of phi. This is the cosine of the phase angle existing between the grid voltage and the current
delivered by the inverter.
If there is no phase angle (0º), the cosine of phi is 1; cos 0º = 1.
Screen 2
Vdc Voltage delivered by the solar panels to the inverter.
Idc Current delivered by the solar panels to the inverter.
Screen 3
Alarm Inverter alarm status. The installer has all the instructions for how to act for each specific alarm. Only
the alarms mentioned in this manual can be of use to the user.
InvNum The number assigned to the inverter through the menu that can be accessed from the display in order
to identify the communications.
Code1 The equipment operating code. It may be requested by the Ingeteam customer service.
Code2 The equipment operating code. It may be requested by the Ingeteam customer service.
SN
The serial number.
Screen 4
TotE Total energy (kWh) delivered by the inverter to the Power grid since it was shipped from the factory. The
recording of the inverter serial number marks the start of the energy log.
T con The number of hours that the inverter has been connected to the Power grid.
NumCon The number of grid connections made during operating hours.
Screen 5
Part E Total energy (kWh) delivered by the inverter to the Power grid since the last counter reset.
Tp con
The number of hours that the inverter has been connected to the Power grid since the last counter
reset.
Npcon
The number of grid connections made since the last counter reset.
Screen 6
FW Ver Inverter firmware version.
DFWVer Inverter display firmware version.
D. Boot Firmware boot version.
3.5. Configuration
To check which country / standards the inverter has been configured for. Access restricted to the installer.
Never change those equipment parameters that can be accessed through this section.
3.6. Language selection
Once the monitoring menu Language has been selected, click on
OK to access the language menu:
The language can be changed through this menu. The and
keys can be used to select the desired language. To select,
position the cursor over the desired language and click once on
OK
.
Click on
OK
once more, to confirm the language selected.
10:22 14/04/11
MAIN MENU
Monitoring
Configuration
Language
Change date