Ingeteam Ingecon mWind 2.5, Руководство по установке

Страница: 19 / 56

In any event, each part of the packaging may be recycled as follows:
• Plastic (polystyrene, bag and bubble wrap): Appropriate container (plastic and bottles).
• Cardboard: Appropriate container (paper and cardboard).
3.2. Handling
Correct handling of the units is vitally important in order to:
• Prevent damage to the packaging which enables them to be kept in optimum condition from shipping until
they are unpacked.
• Avoid knocks and/or falls which may harm their mechanical characteristics, e.g. cause incorrect closure of
the housing, loss of IP rating, etc.
• Avoid, as far as possible, vibrations which may cause subsequent malfunction.
If you observe any anomaly, please contact Ingeteam immediately.
3.3. Transport
Appropriate transport and storage of the unit are the necessary first steps for correct use and operation. Taking
Section “3.2. Handling” into account and as a preventive measure, Ingeteam recommends the use of transport
companies specialised in the transport of special and/or fragile equipment.
All units packaged according to Section “3.2. Handling” must be handled with tools to prevent damage to the
packaging.
The unit must be protected during transport and storage from mechanical knocks, vibrations, water splashes (rain)
and any other product or situation which may damage it or alter its behaviour.
Transport over distances of greater than 5 metres must be carried out using a pallet truck or forklift truck, whenever
possible.
Transport using a pallet truck
At least the following requirements should be observed:
1. Place the packaged units centred with respect to the forks.
2. Try to locate them as close as possible to the connection between the forks and the steering unit.
3. In all cases, observe the instructions in the pallet truck’s user manual.
Transport using a forklift truck
At least the following requirements should be observed:
1. Place the packaged units centred with respect to the forks.
2. Try to locate them as close as possible to the connection between the forks and the steering unit.
3. Ensure that the forks are perfectly level to avoid overturning the unit.
4. In any case, observe the instructions in the forklift truck’s user manual.
Once the unit has been transported to the place where it is to be located and only when it is to be installed, unpack
the unit.
Transport of the unpackaged unit
At least the following requirements should be observed:
1. Use the two side holes to grasp the unit with both hands.
2. Follow the necessary ergonomic advice for lifting weights. The unit weighs between 21 and 24 kg, depending
on its power.
3. Do not release the unit until it is perfectly secured or placed.
4. Ask someone else to guide the movements to be made.
AAY2000IKI04 19
Installation manual Ingeteam Power Technology, S.A.