Page - 4
Z-WAVE CONFIGURATION TABLE
Parameter Description
Length
(Bytes) R/W
Default
Value
Valid Values
1
Time between Battery Reports (hours)
1
R/W
0
0 = Do not send periodically; Range: 1–127 hours
2
Send BASIC SET ON above this temperature (See #20)
1
R/W
121
121 = Disabled; Range: 15 – 120° F
3
Send BASIC SET ON below this temperature (See #20)
1
R/W
121
121 = Disabled; Range: 15 – 120° F
4
Send BASIC SET OFF above this temperature (See #20)
1
R/W
121
121 = Disabled; Range: 15 – 120° F
5
Send BASIC SET OFF below this temperature (See #20)
1
R/W
121
121 = Disabled; Range: 15 – 120° F
6
Send multiple attempts for all BASIC SET commands
1
R/W
0
0 = Disabled; 1-5 = Number of extra attempts sent every
minute after first send
7
Temperature Units
1
R/W
1
0 = Celsius; 1 = Fahrenheit
8
Association Group1 – Temperature delta auto send threshold
1
R/W
10
Range: 1 – 200; Parameter is in tenths of degrees.
9
Association Group1 – Periodic temperature send interval
1
R/W
0
0 = Disabled; Range: 1-120 minutes
10
Association Group2 – Temperature delta auto send threshold
1
R/W
10
0 = Disabled; Range: 1 – 50; Parameter is in tenths of
degrees.
11
Association Group2 – Periodic temperature send interval
1
R/W
0
0 = Disabled; Range: 1-120 minutes
12
Send BASIC SET ON above this humidity (See #20)
1
R/W
0
0 = Disabled; Range: 1–100%
13
Send BASIC SET ON below this humidity (See #20)
1
R/W
0
0 = Disabled; Range: 1-100%
14
Send BASIC SET OFF above this humidity (See #20)
1
R/W
0
0 = Disabled; Range: 1-100%
15
Send BASIC SET OFF below this humidity (See #20)
1
R/W
0
0 = Disabled; Range: 1-100%
16
Association Group1 – Humidity delta auto send threshold
1
R/W
5
Range: 1-50%
17
Association Group1 – Periodic humidity send interval
1
R/W
0
0 = Disabled; Range: 1-120 minutes
18
Association Group3 – Humidity delta auto send threshold
1
R/W
5
0 = Disabled; Range: 1-30%
19
Association Group3 – Periodic humidity send interval
1
R/W
0
0 = Disabled Range: 1-120 minutes
20
BASIC SET options for temperature and humidity
1
R/W
1
Configuration Register Combinations:
1 = Enable Registers 2, 5, 12 15
2 = Enable Registers 2, 5, 13, 14
3 = Enable Registers 3, 4, 12, 15
4 = Enable Registers 3, 4, 13, 14
21
Temperature Offset
1
R/W
0
Range: -7 to 7° F
22
Humidity Offset
1
R/W
0
Range: -7% to 7%
23
Humidity Filter Time Constant
1
R/W
30
Range: 1 – 60 minutes
ASSOCIATION GROUP INFORMATION TABLE
GROUP
PROFILE
COMMAND CLASSES
GROUP NAME
MAX DEVICES
1
Lifeline
Battery Report, Multilevel Sensor Report, Device Reset
Locally Notification
Lifeline
1
2
Sensor
Multilevel Sensor Report
Temperature Reports
5
3
Sensor
Multilevel Sensor Report
Humidity Reports
5
4
Sensor
Basic Set
Temperature Driven Basic Sets
5
5
Sensor
Basic Set
Humidity Driven Basic Sets
5
6
Sensor
Battery Report
Battery Reports
5
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for Class
B Digital Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1)
l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’encompromettre le
fonctionnement.
© 2018 Ingersoll Rand
18-HD85D1-1 Rev. 20180723
Nexiahome.com
U.S.A. / Canada
(877) 288-7707
*
* Configurable through third party Z-Wave systems.
