Ingersoll-Rand VON DUPRIN 7311, Руководство по эксплуатации

Страница: 4 / 17

Features
1. Yellow program LED: Flashes when any key is
pressed, and indicates various programming modes.
2. Red/green LED: Shows status of the relay. Red
indicates locked, green indicates unlocked.
3. Plastic protector: Wraps over circuit board to
prevent wires from shorting against electrical box.
4. J1 jumper: Removing and replacing this jumper
when power is applied to the keypad will force
keypad into programming mode.
5. 4-Pin LED terminal: For 4-pin connector for red
and green LEDs.
6. PA1 terminal pins: For 2-pin LED connector.
7. J2 jumper: 12VDC or 24VDC voltage selector.
8.
+ , -
Input voltage terminals: 12VDC or
24VDC, as selected by J2 jumper.
9. Unlock relay: (NO, C, NC) 2 ampere SPDT
contact controls door strike or other equipment. This
relay contact switches when a correct code or a
request-to-exit input is entered. Actuation time is
programmable.
10. Door position switch input: (White wire)
Connecting a normally closed switch between the
white/orange wire and the white wire allows the
keypad to monitor the door position. The door will
Electrical Box-
/ Not Furnished
LED
Connector
10
pin
connector
Wires
out
bottom
..._Orange/White
White / Brown
@!
@
automatically relock as soon as it closes, preventing
another person from following through an unlocked
door. This automatic relock feature requires the use
of a door position switch. An additional output relay
may be triggered on alarm when used with the 7308
relay board.
11. Request-To-Exit input: (Brown wire) A
momentary closure between the white/orange wire
and the brown wire will activate the unlock relay for
the same time period as programmed for the master
code. NOTE: This will only work if the door position
switch is closed.
1. Locate keypad at height to suit user. Check
handicap requirements in your jurisdiction.
2. Install keypad in a single-gang electrical box (not
furnished}.
Pull wires to junction box:
3. Pull power supply wires
4. Pull door lock wires
5. Pull door position switch wires, if equipped
6. Pull request-to-exit switch wires, if equipped
Install 7311 keypad:
7. Install gasket between keypad and wall (sticky
side toward keypad).
8. Attach keypad to single-gang electrical box (not
furnished) with supplied screws.