Ingersoll-Rand Thermo King SGCM 4000, Руководство по обслуживанию

Страница: 163 / 181

Structural/Accessory Maintenance
162
3. Insert the foot of the mounting clamp fully into the container mounting hole. Pull lock pawl handle
forward. Pull the clamp handle down to rotate the clamp shaft bolt 90° and clamp generator set to
container.
4. Release the lock pawl to hold the clamp handle in the locked (down) position.
5. Check to be sure the generator set frame fits tightly against the container. Turning the mounting clamp
handle should pull the generator set frame tight against the container front wall. If necessary, tighten
the mounting clamp. The mounting clamp can be tightened or loosened by turning the nut on the head
of the clamp shaft.
CAUTION: Watch the clamp flat on threaded end of the mounting shaft when rotating the
handle. The clamp flat should turn as the clamp handle rotates. With the mounting clamp in the
locked position (handle down), the clamp flat must be horizontal. If the flat is not horizontal,
check the clamp handle for a broken shoulder screw.
CAUTION: Excessive vibration or unit malfunction can occur if mounting clamps are not
properly secured. The generator set MUST be tight against the container.
1. Lift (Unlock) Lock Pawl 5. Lift (Unlock) Lock Pawl
2. Rotate Clamp Handle Up 90 degrees 6. Rotate Clamp Handle Down 90 degrees
3. Release (Lower) Lock Pawl 7. Release (Lower) Lock Pawl
4. Insert Mounting Clamp Foot in
Container Mounting Hole 8.
Figure 78: SGCO 4000 Clip-on Corner Clamp Installation Procedure
AXA0332