Ingersoll-Rand SRA010A1, Информация о продукте

Страница: 4 / 52

EN-2 16581993_ed2
EN
3. Raise the Saw slowly to an upright position, keeping the Saw Guide firmly against the material.
Guide the Saw in this position along the direction of the cut.
4. When cutting metal from an edge, hold the Saw as shown in Figure 3, keeping the Saw Guide
firmly against the work to prevent vibration of the metal and blade chattering. When making
direct cuts into metal, first chisel or drill a starting hole.
(Figure 3)
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16582009 and table on page 2. Maintenance frequency is shown in a circular
arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter 6. Thread size
2. Regulator 7. Coupling
3. Lubricator 8. Safety Air Fuse
4. Emergency shut-off valve 9. Oil
5. Hose diameter 10. Grease - during assembly
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.