Ingersoll-Rand HP825WCU, Руководство по эксплуатации, техническому обслуживанию и каталог запасных частей

Страница: 27 / 434

Book 35393560 (12/02)
27
( )
SECTION 5 -- OPERATION
WARNING
Do not climb on top of unit. The lifting eye can
be reached through the roof door ONLY from
INSIDE of the unit.
DISCONNECT and SET -- UP
S
Place the unit in an open, well--ventilated area.
Position as level as possible. The design of these units
permits a 15 degree sidewise limit on out--of--level
operation.
When the unit is to be operated out--of--level it is
important:
(1) To keep the engine crankcase oil level near the
high
level mark (with the unit level),
(2) To have the compressor oil level gauge show no
more than mid--scale.
COMPRESSOR MOUNTING
Portable compressors, which are modified to remove
the running gear and mount the machine direct to trail-
ers, truck beds or frames, etc. may experience failure
of the enclosure, frame, and/or other components. It
is necessary to isolate the compressor package from
the carrier base with a flexible mounting system. Such
a system must also prevent detachment of the pack-
age from the carrier base in the event the isolators fail.
Contact Ingersoll--Rand representative for flexible
mounting kits.
Warranty does not cover failures attributable to
mounting of the compressor package to the carrier
base unless it is an Ingersoll--Rand provided system.
COMPRESSOR OIL LEVEL
The oil level should be checked before the unit is
started. Always check the oil level while the unit is
level, the engine off, and there is zero pressure in the
separator tank. The optimum oil level is with the
pointer at the top of the green section on the level
gage. Add oil if the pointer reaches the bottom of the
green section.
Note: The oil level gage will not read properly while the
engine is running.
YELLOW -- TOO HIGH
GREEN -- OK
TOO LOW
RED
OPTIMUM OIL LEVEL
(EITHER SIDE)
ADD OIL LEVEL
(EITHER SIDE)
Do not overfill either the engine crankcase or the
compressor.
DISCONNECT
Engage parking brakes and chock wheels of both tow
vehicle and compressor.
Stand aside while:
S
Withdraw pin, swing jack down and fully insert pin to
lock in down position.
S
Disconnect safety chains from tow vehicle.
S
Disconnect brake actuator chain from tow vehicle.
S
If so equipped, disconnect running light plug from the
tow vehicle.
S
Operate drawbar jack to raise pintle eye from hitch
of tow vehicle.
BEFORE TOWING
Units equipped with hydraulic brakes:
Check brake fluid level. Top off as required with DOT
3 brake fluid.
Check condition of brake lines, hoses and cables.
Repair or replace damaged parts.
Attach brake actuator breakaway chain above hitch
on towing vehicle.