Ingersoll-Rand HC-103, Руководство пользователя

Страница: 62 / 128

ALLEN-BRADLEY PANELVIEW PLUS 400
OPERATIONAL GUIDE
Reference IR - 196 – I-R Allen-Bradley PanelView Plus 400 – for I-R HC w/HL or HC Mode Rev 4
Page 5 of 11 01/20/2015
B. Status (Continued)

When HL Mode is enabled, this will toggle from REGENERATION (for 210 seconds)
to REPRESSURIZATION (for 30 seconds).

If the optional Dew Point Demand System (DPDS) is installed, the status will also
indicate STANDBY at the end of the regeneration cycle.
In the bottom left corner of the Status screen, the time remaining in the current
regeneration cycle is displayed. Note: If the dryer is in DPDS Standby, the time will
remain at zero and does not reset until the dew point rises above the dew point set point
(factory preset is -20°F).
In the lower right corner of the Status screen is the screen selector list similar to the one
on the MAIN screen. Use the up or down arrow key to select the screen you want to
view; then press the enter key.
C. Settings
Upon entering the Settings screen, the screen below will appear. On this screen, press
F7 to continue to Settings.