Ingersoll-Rand ES 115V AC Series, Информация о продукте

Страница: 3 / 12

45527678_ed1 EN-2
EN
Torque Adjustment
To adjust the torque on these screwdrivers, proceed as follows:
Determine the torque output of the tool by checking a tightened fastener with a torque
wrench.
Increase or decrease the torque output by rotating the Spring Adjusting Ring. Rotating
the Ring clockwise to a higher number on the Torque Scale increases torque output while
rotating the Ring counterclockwise to a lower number decreases the torque output.
NOTICE
The numbers on the Torque Scale are reference numbers only and are not an indication of
actual torque output.
3. Check the adjustment with a torque wrench. A number of factors will affect torque output
from one job to another. Final torque adjustment should be made at the job through a series
of gradual increases. Always start below the desired torque and work upward.
Grounding Instructions
The tool should be grounded while in use to protect the operator from electric shock. The
tool is equipped with a three-conductor cord and three-prong grounding-type plug to fit the
proper grounding-type receptacle. The green (or green and yellow) conductor in the cord is
the grounding wire. Never connect the green (or green and yellow) wire to a live terminal. If
your unit is for use on less than 150V, it has a plug that looks like that shown in Figure A. An
adapter (see Figure B) is available for connecting Figure A-type plugs to 2-prong receptacles.
The greencolored rigid grounding strap must be connected to a permanent ground such as to a
properly grounded outlet box as shown in Figure C.
Grounding
Blade
Grounding Means
Adapter
FIGURE B
FIGURE A FIGURE C
Cover Of
Grounded
Outlet Box
(Dwg. TPD446-1)
WARNING
For safe use of adapters, the outlet box must be grounded. If there is any doubt, have a
qualified electrician check connections.
Use only 3-wire extension cords that have 3-prong grounding type plugs and 3 pole
receptacles that accept the plug. Replace or repair damaged cords.
1.
2.