Ingersoll-Rand DAA40 Series, Руководство по обслуживанию

Страница: 3 / 15

2–3
LUBRICATION
Adequate lubrication is imperative for maximum performance and durability of the gearing in these Tools.
Ingersoll–Rand No. 10 Oil
The use of an air line lubricator is recommended. For permanent installations, we recommend using an Ingersoll–Rand
No. C18–03–FKG0–28 Filter–Lubricator–Regulator Unit.
If an air line lubricator is not used, inject 2 cc of the recommended oil into the air inlet before attaching the air hose and after
each eight hours of operation.
ADJUSTMENTS
Before placing your Ingersoll–Rand Torque Control Wrench Hand–Held Power Module in service, several optional adjust-
ments can be made to the unit which will enhance the performance of the tool or improve operator comfort. Selection and
adjustments should be made prior to placing the tool in service.
TOP/REAR AIR INLET
The air supply hose can be connected conventionally to the rear of the unit or connected to the side of the Handle if an over-
head air supply is available. To change the inlet connection, proceed as follows:
Do not remove the Inlet Plug (24) without first disconnecting the live air supply.
Do not thread pipe thread fittings directly into the Inlet Bushing or Inlet Plug locations in the Handle.
1. Disconnect the air supply hose if it is attached to the tool.
2. Using an adjustable wrench, unscrew and remove the Inlet Bushing (3) and Inlet Bushing Seal (5).
3. Using a 1/4” hex wrench, unscrew and remove the Inlet Plug (24) and Inlet Plug Seal (25).
4. Install the Inlet Plug and Seal in the desired location and tighten the Plug between 30 and 40 in–lb (3.4 and 4.5 Nm)
torque. (Refer to TPD1844).
(Dwg. TPD1844)