Ingersoll-Rand BXR-100H, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 262

BXR-100H Reversible Plate Compactors
7-EN Operation & Maintenance Manual
EN
Starting
1. Turn the ENGINE SWITCH [Figure 2] to the “ON” position.
Figure 2
2. Move the fuel valve lever [Figure 3] to the “ON” position.
Figure 3
3. Close the CHOKE LEVER [Figure 4] .
If the engine is cold or the ambient temperature is low, close
the Choke Lever fully. If the engine is warm or the ambient
temperature is high, open the Choke Lever half-way, or keep
it fully open.
Figure 4
4. Position the THROTTLE LEVER (
c
, [Figure 5] ) to “LOW”
speed position.
Figure 5
5. Pull the STARTER HANDLE (
c
, [Figure 6] ) of RECOIL
STARTER slowly until resistance is felt. This is the
“COMPRESSION” point. Return the Handle to its original
position and pull swiftly. After starting the engine, allow the
Starter Handle to return to its original position while still
holding the Handle.
Figure 6
After the engine starts, allow it to run at the low speed and
warm it up without load for about five minutes. Fully open
CHOKE LEVER
[Figure 4] gradually.
CAUTION
Avoid fully pulling out the rope. Return the Handle to its
original position.
ENGINE SWITCH
FUEL VALVE
LEVER
ON
CHOKE LEVER
CLOSE
OPEN
STARTER GRIP