Ingersoll-Rand BP10P3, Руководство по эксплуатации и обслуживанию

Страница: 5 / 15

5
PLACING TOOL IN SERVICE
Disposal of Worn Out Battery
Return the worn out Battery to the distributor from which
it was purchased as soon as the post charging battery life
becomes too short for practical use.
Charging the Battery
Use only the models of Battery Chargers listed in the
section of this form PLACING THE TOOL IN
SERVICE, for charging the BP10P3–950 Battery.
For continuos service of the Impulse Tool, a spare Battery
should be kept on hand for alternate use.
During the initial charge or after the Battery has not been
used for a long time, the Battery may not take a full
charge. If this occurs, use the Battery in the Impulse Tool
again before resuming the charging cycle. It should then
accept a full charge.
1. Disengage the Battery by depressing the button on
the Battery to release the latch and then pulling the
Battery out the bottom of the housing handle.
2. Insert the AC power cord of the Battery Charger into
the power receptacle.
3. Insert the Battery into the charger making sure that
the positive (+) and negative (–) sides are properly
oriented. The Charger has a series of lines embossed
to match the lines on the battery when the Battery is
properly positioned. Additionally, the Battery will
not fully enter the Charger if the orientation is off
180
_
from correct insertion. When properly inserted,
the power indicator light will remain red.
4. When the Battery is fully charged, the red light will
flash in half second intervals.
If the light blinks in one tenth or two tenths of a
second intervals, a charging problem exists.
Consult the Battery Charger Manual for probable
causes and solutions.
Changing Rotational Direction
Before operating the Impulse Wrench, make certain the
socket is rotating in the direction required for the job
application.
Do not attempt to change rotational direction while the
tool is running or without releasing the Trigger Switch.
Failure to do so can cause damage to the Trigger
Switch.
The forward/reverse lever is located at the top of the
Trigger Switch. To change direction, proceed as follows:
1. Hold the tool in a normal manner and release the
Trigger Switch.
2. For right hand or clockwise rotation, push the lever
completely to the right.
3. For left hand or counterclockwise rotation, push the
lever completely to the left.
HOW TO ORDER AN IMPULSE WRENCH
Model Free Speed Recommended Torque Range
Soft Draw Hard Slam
in–lb Nm in–lb Nm
PISTOL GRIP with 1/4” INSERT BIT CHUCK
BP109PQ1 2200 80–142 9–16 97–168 11–19
PISTOL GRIP with 3/8” SQUARE DRIVE
BP10P3 2200 80–142 9–16 97–168 11–19