Ingersoll-Rand A801X026AM2SAB, Руководство по установке

Страница: 10 / 56

10 88-A801X001-1B-EN
W Wa arrn niin ng g:: T Th he esse e ffu urrn na acce ess a arre e n no ott a ap pp prro ov ve ed d o orr
iin ntte en nd de ed d ffo orr iin nsstta alllla attiio on n iin n m ma an nu uffa accttu urre ed d ((m mo ob biille e))
h ho ou ussiin ng g,, ttrra aiille errss,, o orr rre eccrre ea attiio on na all v ve eh hiicclle ess..
Locations and Clearances
The location of the Furnace is normally selected by the
architect, the builder, or the installer. However, before
the Furnace is moved into place, be sure to consider
the following requirements:
1. Is the location selected as near the chimney or vent
and as centralized for heat distribution as practical?
2. Do all clearances between the Furnace and
enclosure equal or exceed the minimums stated in
Clearance Table below?
0LQLPXP FOHDUDQFH WR FRPEXVWLEOH PDWHULDOV
3. Is there sufficient space for servicing the Furnace
and other equipment? A minimum of 24 inches
front accessibility to the Furnace must be provided.
Any access door or panel must permit removal of
the largest component.
4. Are there at least 3 inches of clearance between the
Furnace combustion air openings in the front panel
and any closed panel or door provided?
5. Are the ventilation and combustion air openings
large enough and will they remain unobstructed? If
outside air is used, are the openings set 12" above
the highest snow accumulation level?
6. Allow sufficient height in supply plenum above the
Furnace to provide for cooling coil installation, if
the cooling coil is not installed at the time of this
Furnace installation.
F Fu urrn na acce e IIn nsstta alllla attiio on n G Gu uiid de elliin ne ess