8
PLACING TOOL IN SERVICE
LUBRICATION
Protec Engine Oil
Always use an air line lubricator with these tools.
We recommend the following Lubricator–
Unit and Lubricant:
In Line Lubricator:
CPN: 35371111
Lubricant: Protec Engine Oil CPN: 85448405
Attach the lubricator as close to the tool as practical.
After each two or three hours of operation and at
the beginning of each work shift, if an air line lubri-
cator is not used, disconnect the air hose and pour
about 3 cc of oil into the air inlet of the tool.
Before storing the tool or if the tool is to be idle for a
period exceeding twenty-four hours, pour about 3 cc
of oil into the air inlet and operate the tool for 5 sec-
onds to coat the internal parts with oil.
INSTALLATION
Air Supply and Connections
Always use clean, dry lubricated air. Dust, corrosive
fumes and/or excessive moisture can ruin the motor
of an air tool. An air line filter can greatly increase
the life of an air tool. The filter removes dust and
moisture.
Make sure all hoses and fittings are the correct size
and are tightly secured. See diagram PP1 for a typ-
ical piping arrangement.
The tool is shipped from the factory with 3/4” NPT
male inlet thread and quick release coupling.
Diagram PP1
