Ingersoll-Rand 7RL Series, Информация о продукте, Страница: 3 / 16

80227531_ed2 EN-1
EN
Product Safety Information
Intended Use:
These tools are designed to remove and install threaded fasteners.
WARNING
Failure to observe the following warnings, and to avoid these potentially hazardous
situations, could result in death or serious injury.
Always turn off the air supply, bleed the air pressure and disconnect the air supply hose
when not in use, before installing, removing or adjusting any accessory on this tool, or
before performing any maintenance on this tool or any accessory.
If a tool stalls the full torque capacity of the tool will be applied to the operator’s hands,
unless a suspension arm or reaction bar is used. This force may cause serious personal
injury from crushing, pinching, loss of balance or loss of control of the tool.
For additional information refer to Product Safety Information Manual Form 04585006.
Manuals can be downloaded from ingersollrandproducts.com.
Product Specifications
Models Clutch Type
Torque Range
(soft draw)
Free Speed Square Drive
Clutch Spring
in-lb (Nm) rpm in
7RLL2C6 Cushion 15-100 (1.7-11.3) 1400 3/8 H
7RLL3C6 Cushion 25-110 (2.8-12.5) 1400 3/8 M
7RLM3C6 Cushion 25-130 (2.8-14.8) 800 3/8 M
7RLL3D6 Stall 100 (11.3) 1400 3/8 ---
7RLM3D6 Stall 175 (19.8) 800 3/8 ---
7RLN3D6 Stall 265 (29.9) 500 3/8 ---
Models
Sound Level dB(A)
(ISO15744)
Vibration Level
(ISO28927)
† Pressure (L
p
) m/s²
7RLL2C6 78.6 < 2.5
7RLL3C6 75.9 < 2.5
7RLM3C6 76.3 < 2.5
7RLL3D6 75.9 < 2.5
7RLM3D6 75.9 < 2.5
7RLN3D6 78.5 < 2.5
† K
pA
= 3dB measurement uncertainty
WARNING
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
●
●
●