Ingersoll-Rand 4TXM6518A1, Руководство по установке

Страница: 7 / 15

All power cables and connection cables must be protected with conduits.
Wrong wire connection may cause malfunction of some
electric components.After fixing cable, ensure that
leads between connection to fixed point have some space.
2
.
3.
4.
5.
Remove the cable clamp, connect the connection
1. Remove the handle at the right side plate of the
outdoor unit (six screw).
Fix power connection wire by wire clamp.
Ensure wire connections are tight and secure .
Install the handle.
ELECTRICAL CONNECTIONS INS TALLER
the unit A and unit B must be corresponding to each
other respective.
national wiring regulations.
To the power supply
To unit B
cable cable
To unit A
5
4TXM6518A1020BA
4TXM6518A1020BA
L1 L2
L1
L1
L2
L2
.
ELECTRICAL CONNECTIONS INS TALLER
cable
cable cable
5
power
cable and power cable with the terminal at the row of
connection and
tighten the connection. The fitting line
distributing must be consistent with the indoor unit
terminal of line bank.
Wiring should meet that of indoor unit.
The connection pipes and the connectiong wirings of
The appliance shall be installed in accordance with
Note: the above figures are only intended to be a simple
diagram of the appliance and may not correspond to the
appearance of the units that have been purchased.
connecting
connecting
Be sure the electrical supply is connected
to a equipment disconnect device approved
for this application.
Warning and Caution
1.
2.
3.
4.