Ingersoll-Rand 2934B2SP, Руководство по эксплуатации и обслуживанию

Страница: 18 / 19

18
MAINTENANCE SECTION
TROUBLESHOOTING GUIDE
Trouble Probable Cause Solution
Low power Dirty Inlet Bushing or Air
Strainer Screen and/or Exhaust
Silencer Using a clean, suitable, cleaning solution, in a well
ventilated area, clean Air Strainer Screen, Inlet
Bushing and Exhaust Silencer.
Worn or broken Vanes Replace complete set of Vanes.
Worn or broken Cylinder and/or
scored End Plates Examine Cylinder and replace it if it is worn or
broken or if bore is scored or wavy. Replace End
Plates if they are scored.
Dirty motor parts Disassemble tool and clean all parts with a
suitable cleaning solution, in a well–ventilated area.
Reassemble tool as instructed in this manual.
Improper positioning of Reverse
Valve Make certain that Reverse Valve is fully
engaged to the left or right.
Motor will not run Incorrect assembly of motor Disassemble motor and replace worn or broken
parts and reassemble as instructed.
Insufficient lubricant in the
impact mechanism Remove Hammer Case Assembly and lubricate
impact mechanism.
Tool will not impact Broken or worn impact
mechanism parts Remove Hammer Case and examine impact
mechanism parts. Replace any worn or broken
parts.
Impact mechanism not assembled
correctly Refer to Assembly of the Impact Mechanism.
SAVE THESE INSTRUCTIONS. DO NOT DESTROY.