Ingersoll-Rand 125-A, Информация о продукте

Страница: 3 / 56

47680581001_ed1 EN-1
EN
Product Safety Information
Intended Use:
These Air Percussive Scalers are designed for removal of unwanted deposits from metal and
other hardened materials through repetitive application of linear impacts of hardened needles
or a tool steel that is retained and driven by the Scaler. Such deposits include weld spatter, paint,
coatings and other surface materials.
For additional information refer to Product Safety Information Manual Form 04581450.
Manuals can be downloaded from ingersollrandproducts.com.
Accessory Installation
WARNING
●
Always use appropriate retainer, latch or sleeve, in addition to proper barriers to protect
persons in surrounding or lower areas from possible ejected accessories.
● Always turn off the air supply, bleed the air pressure and disconnect the air supply hose
when not in use, before installing, removing or adjusting any accessory on this tool, or
before performing any maintenance on this tool or any accessory.
● To install or remove a Chisel or other accessory, hold the tool by the Casing (18) and
push hard on the Bit Retainer (22).
Prior to Use
WARNING
●
Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel or jet
fuel. Use only recommended lubricants.
●
Use only proper cleaning solvents to clean parts. Use only cleaning solvents which meet
current safety and health standards. Use cleaning solvents in a well ventilated area.
Tools are coated inside and out with rust-resisting oil before leaving the factory. Before using the
tool, remove this oil by dipping the tool in a suitable cleaning solution to wash the oil from the
exterior. Pour about 6 cm 3 of a clean, suitable, cleaning solution into the air inlet and operate the
tool for about 15 seconds. Dry the tool immediately after cleaning, pour 3 cm
3
of Ingersoll Rand
No. 10 Oil into the air inlet and again operate the tool for 5 seconds to lubricate all working parts.
Product Specifications
Models
Blows per
Minute
Stroke
Length
Sound Level dB(A)
(ISO15744)
Vibration (m/s²)
(ISO28927)
Inch (mm) † Pressure (L
p
) ‡ Power (L
w
) Level *K
125-A
4,800 1-1/8 (28.6) 96.3 107.3 9.6 1.3
125CI-A
† K
pA
= 3dB measurement uncertainty * K = Vibration measurement uncertainty
‡ K
wA
= 3dB measurement uncertainty