Ingenico AXIUM D7, Руководство пользователя

Страница: 14 / 29

Copyright© 2019 Ingenico
All rights reserved
900034667 R11 000 04/0119
14
AXIUM D7
4_3
Change of the battery
It is imperative to use a battery authorized by Ingenico.
There is danger of explosion if battery used is not approved
by Ingenico.
Remove the terminal from its base
Turn it off by pressing the ON/OFF Key
Remove the battery trapdoor (see section 3.1“installing
battery”)
Carefully disconnect battery, following the instructions below.
Connect and install the new battery by following the instructions
in section 3.1 “Installing battery”
Close the battery trapdoor and charge the new battery. See
section «Charging the Battery 4.2»
In order to preserve the environnement, dispose used battery in
compliance with current country recycling legislation.
Note : The terminal memorizes that there is no battery simply by
powering up. It will then correctly perform-full recharge with the next
battery.
Main battery
Axium D7 is fitted with battery specially designed for this terminal.
Only use the appropriate chargers and batteries listed in the
Ingenico’s catalogue.
Do not short-circuit the battery.
Do not attempt to open the battery container.
Used batteries must be disposed of at the appropriate sites.
Electrical power supply network
Provide and electrical outlet :
Located near the equipment and easily accessible;
Which meets the standards and regulations in the country of
use;
The terminal Axium can be connected to a power distribution
system of the IT type for Norway.