13|English
4.
SWITCH
(see fig 4)
The On/Off trigger switch is sprung in the OFF position.
The angle grinder is started by pushing forward the
on/off switch. See fig 4. To stop the angle grinder,
release the on/off switch and it will return to the OFF
position.
WARNING!
The disc will continue rotate for a few
seconds after the angle grinder has been switched off.
Fig 4
Fig 5
Always wait until the disc has stopped completely
before putting the angle grinder down. Do not attempt
to operate the spindle lock button while the disc is still
rotating.
5.
TO USE GRIND
(see fig 5)
Attention: Do not switch the grinder on whilst the disc
is in contact with the workpiece. Allow the disc to reach
full speed before starting to grind. Hold your angle
grinder with one hand on the main handle and other
hand firmly around the auxiliary handle.
Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
Be prepared for a stream of sparks when the disc
touches the metal.
For best tool control, material removal and minimum
overloading, maintain an angle between the disc and
work surface of approximately 15°-30° when grinding
and 10°-15° When sanding. Exert light pressure on
abrasive discs for efficient operation. Pushing too
hard will cause a drop in speed and may result in
motor overload and damage.
Use caution when working into corners as contact
with the intersecting surface may cause the grinder
to jumo or twist, When grinding is complete allow the
workpiece to cool. Do not touch the hot surface.
6. OVERLOAD
Overloading will cause damage to the motor of your
angle ginder. This can happen if your angle grinder
is subjected to heavy use for prolonged periods of
time. Do not in any circumstances, attempt to exert
too much pressure on your angle grinder to speed
up your work.
On/off
switch button
