12|English
OPERATION INSTRUCTIONS
WARNING: Before using your angle grinder be sure
to read the instruction manual carefully.
1. INSTALLING THE AUXILIARY HANDLE
(see fig 1)
An auxiliary handle is supplied and can be fixed into
both of the two positions on the gearcase. If you are
right handed fit the handle as shown in fig1. If you are
left handed fit the handle the other way round. When
using a cutting disc, you can screw the handle into the
position on top of the gearcase.
NOTE: This handle should be used at all times to
maintain complete control of the tool.
2. ADJUSTING WHEEL GUARD (see fig 2)
Adjust the guard to protect your hands and direct
grinding debris. Loosen the screw. Position the guard
at the required angle. Then tighten the screw.
CAUTION: Be sure that the guard is secure before
starting the angle grinder.
WARNING: Never use the angle grinder without the
disc guard in place.
3. FITTING THE DISCS (see fig 3)
Place the grinding/cutting disc on top of the inner flange
and over the spindle. Ensure that it is firmly located on
the raised section of the inner flange. See fig3. Locate
the outer flange over the disc, making sure that the
raised side is facting the disc and is fully located in the
centre hole of the disc.
NOTE: When clamping thin section metal diamond
discs, the outer flange must be reversed so that the
flat/dished side screws against the disc hub.
Press and hold down the spindle lock button and
tighten the outer flange using the two pin locking
wrench. It may be necessary to turn the spindle to
fully locate the spindle lock button.
When the outer flange washer is tight, release the
spindle lock button and remove the wrench.
Screw
Spindle
