Ingco ABN15501, Руководство пользователя

Страница: 9 / 14

Specification
Magzine capacity …………… ………………………………..…100pcs
Nail length…………………………………………….……..……15-50mm (5/8
˝ - 2 ˝ )
Fastener size……………………………..…………………….….18Gauge (1.25
×
1.00mm)
Operation pressure…………………………………………………4-7bar (58-101.5PSI)
Air inlet…………………………………………………..………..1/4
˝ N.P.T.
Dimension……………………………………………..…………..55
×
235
×
255mm
Weight………………………………………………..……..……..1.55kgs
Accessories included:
1000pcs brads (50mm)
1pcs safety goggles
1pcs oil bottle
2pcs hex keys
Operating instruction
Model ABN15501 drives Ga.18 brad nails from 15mm to 50mm length. Die cast aluminum body for strong
and light weight. Comfort grip rubber handle for improved control and comfort even during extended use.
Touch-strike security system safe for the operator. New type magazine release latch. 2 springs magazine
push the nails smoothly . Quick release nosepiece for fact clearing of jams. It is ideal for door and window
trims, decorative trim, and cabinet work, finish paneling, frames, flooring and etc.
Air supply
1. Use clean, Dry and Regulated compressed air at 4-7 bar (58-101.5psi)
2. Never exceed maximum and minimum pressure. Too low or too high pressure would cause noise,
fast-worn or misfiring.
3. When connecting air supply always keep hands and body from discharge area of tool.
4. A filter-regulator-lubrication is required and should be located as close to tool as possible.(see fig 4.)
5. Keep air filter clean. A dirty filter will reduce the air pressure to the tool causing a reduction in power and
efficiency.
6. For better performance, install a quick connector in your tool and quick coupler on the hose if possible.
7.
Be sure all connections in air supply system are sealed to prevent air loss.
9